Dryer Vent Hose Replacement in Houston, TX

Why does the hose behind the dryer keep crushing?

Usually because the dryer sits too close to the wall. Shallow laundry closets in Houston condos leave inches, not feet. The flex hose folds into an S and kinks. Lint catches in every fold. White vinyl is the worst offender, and most codes no longer allow it. Semi-rigid aluminum holds a bend without collapsing. A rigid 90-degree periscope box works better in tight closets.

The hose is only the transition piece. It connects the dryer to the wall duct, and it should stay short and visible. Hiding extra slack behind the appliance defeats the point. On 1950s–70s ranch homes near the Loop, that wall duct is a short run straight through brick. On 1990s–2000s two-story subdivisions out in Katy or Cypress, it climbs into the attic and crosses to a roof jack with several elbows.

Each elbow counts against the 35-foot equivalent length limit. Count yours before blaming the hose. If the real problem is a clogged roof flapper or a crushed attic section, a new transition hose changes nothing.

Signs to watch: jeans damp after two cycles, a hot laundry room, a scorched smell, mildew spreading on closet drywall.